Ecotech VorTech MP40 Dry Side Gasket

Replacement dry side gasket for the MP40wQD. **Not compatible with EcoSmart or older MP40w Drysides** EcoTech VorTech Alignment and Dryside Spacer Use. (MP10, MP40 and MP60) All VorTech Drysides.

Replacement dry side gasket for the MP40wQD.

**Not compatible with EcoSmart or older MP40w Drysides models**

EcoTech VorTech Alignment and Dryside Spacer Use. (MP10, MP40 and MP60) All VorTech pumps must

*Never run a submersible pump (such as the VorTech) outside of water as this may damage the pump.

• 1. Measure your glass.
• 2. Choose the correct spacer (varies between MP10, MP40 and MP60 pump).
• 3. Apply the spacer to the Dryside (engine)
• 4. Choose your mounting location (Tip: too high will suck in air, too low can move your sand bed - avoid obstructions in the tank, e.g. rockwork - the more open space around the pump, the more overall water movement you will achieve)
• 5. Attach the pumps with the pump turned off and use the hanging tab. The hanging tabs are designed to protect the Dryside from falling and damage. If you are not mounting the tabs above the VorTech, make sure the tab is less than half the distance is between the engine and any surface the engine may come into contact with.
• 6. Adjust the alignment until there is no noise or excessive vibration.
• 7. Adjust/program your VorTech if necessary