Milwaukee TDS waterproof hand tester, manual calibration - 0-1999 ppm

The Milwaukee T75 TDS meter is specifically designed for water analysis in aquariums, aquaculture and swimming pools. Replaceable electrode. Range 0 to 1999 ppm....

Milwaukee TDS waterproof hand tester, manual calibration - 0-1999 ppm

Milwaukee T75 Digital TDS Meter with Replaceable Electrode

The Milwaukee T75 TDS meter is specifically designed for water analysis in aquariums, aquaculture and swimming pools. Replaceable electrode. Range 0 to 1999 ppm.

Benefits Milwaukee T75 Digital TDS Meter with Replaceable Electrode

• Waterproof TDS meter with replaceable electrode!
• One of the most accurate, robust and reliable testers on the market!
• Made in Europe!

Description Milwaukee T75 Digital TDS Meter with Replaceable Electrode

The Milwaukee T75 TDS (Total Dissolved Solids) meter is specifically designed for water analysis in aquariums, aquaculture, agriculture and swimming pools. With the T75 the TDS value of the water can easily be measured. The calibration procedure is very simple and fast. This tester has automatic temperature compensation, 1 ppm resolution and a range of 0 to 1999 ppm.

With this Milwaukee TDS meter you can measure solutions with very low to very high conductivity. The T75 is equipped with an automatic temperature variance which ensures an accurate measurement.

TDS electrodes can become contaminated over time. Always rinse the electrode with clean tap water after each use to minimize dirt build-up.

Specifications Milwaukee T75 Digital TDS Meter with Replaceable Electrode

• Range: 0 to 1999 ppm (mg/L)
• Resolution: 1ppm (mg/L)
• Accuracy: ±2% full scale
• Typical EMC deviation: ±2% full scale volledige
• Calibration: Manual, at 1 point by trimmer
• Replaceable probe: MA73075
• Temperature compensation: Automatic from 0 to 50°C (32 to 122, with ß=2%/°C
• TDS factor: scale 0.5
• Operating conditions: 0 to 50°C / 32 to 122°F; maximum RH 100%
• Battery type: 3 x 1.5V Alkaline (included)
• Battery Life: Approx. 250 hours of continuous use
• Calibration solution: M10032B (25 sachets of 20 ml each)
• Dimensions: 180 x 65 x 32mm
• Weight: 99 grams

Package contents

• Milwaukee T75 TDS gauge
• protective cap
• Instructions
• 1x M10032B TDS 1332 ppm calibration solution 20ml
• Batteries