D&D JUMPGUARD PRO DIY AQUARIUM COVER 180CM X 90CM

DD Jumpguards are a very lightweight, slim, low visual impact and easy to construct screen cover suitable for most aquarium species, specially designed to prevent fish loss as a result of ...

D&D JUMPGUARD PRO DIY AQUARIUM COVER 180CM X 90CM

There is nothing worse than going down early in the morning to find your favorite fish dead and crispy on the carpet.

Many fish, especially wrasse, tend to jump out of the tank if they are frightened or chased by another fish and therefore, to prevent the loss of such fish, this solution should be high on every priority list of holders of such fish stand.

DD Jumpguards are a very lightweight, slim, low visual impact and easy to construct screen cover suitable for most aquarium species, specially designed to prevent fish loss due to jumping while maintaining high light penetration.

Available in the following versions and are designed to be cut to size:

• TC7575PRO - 75 cm x 75 cm nominal size.
• TC12075PRO - nominal size 120 cm x 75 cm.
• TC18075PRO - nominal size of 180 cm x 90 cm.

Comments

The frame with the maximum size that can be made from each set is 3.6 cm longer than stated in each direction.
The tank must be measured from the inside of the glass to the inside of the glass.

Included in the kit

The Jumpguard Pro Aquarium Cover is a set of parts with which the aquarist can make a special frame for their specific aquarium. The rigid corners and the extruded aluminum profile create a very solid frame that sits neatly in the glass of the aquarium glass and rests on the upper lip.

Content of the set:

• 4 x aluminum frame parts
• 4 x plastic corners
• 2 x plastic handles
• 1 x Length of rubber spline
• 1 x sheet of black mesh
• 1 x Spline rolling tool
• 1 x manual
• 2 x inverted corners to form flexi recess
• 1 x Brace bar (TC7575PRO), 2 x Brace bars (TC12075PRO), 3 x Brace bars (TC18090PRO) + clips and attachments

Video D&D JUMPGUARD PRO DIY AQUARIUM COVER 180CM X 90CM